Windows XP – svchost %100 sorunu

Konu RE: svchost %100

 

  

makale: http://support.microsoft.com/kb/932494/en-us

 

update: http://www.microsoft.com/downloads/details.aspx?familyid=7A81B0CD-A0B9-497E-8A89-404327772E5A&displaylang=en

 

Problem: svchost.exe is using %99 percent of CPU. Because of this, the customer was unable to use his notebook. He mentioned that first he installed kb927891 update to solve his problem after the searches he has done through the net. But the update he installed, didn’t solve his problem so he tried the steps below.

1. Click Start->Run, type “services.msc” (without quotation marks) in the

open box and click OK.

2. Double click the service “Automatic Updates”.

3. Click on the Log On tab, please ensure the option “Local System account”

is selected and the option “Allow service to interact with desktop” is

unchecked.

4. Check if this service has been enabled on the listed Hardware Profile. If

not, please click the Enable button to enable it.

5. Click on the tab “General “; make sure the “Startup Type” is “Automatic”.

Then please click the button “Start” under “Service Status” to start the

service.

6. Repeat the above steps with the other service: Background Intelligent

Transfer Service (BITS)

Step 4: Re-register Windows Update components and Clear the corrupted

Windows Update temp folder

1. Click on Start and then click Run,

2. In the open field type “REGSVR32 WUAPI.DLL” (without quotation marks) and

press Enter.

3. When you receive the “DllRegisterServer in WUAPI.DLL succeeded” message,

click OK.

4. Please repeat these steps for each of the following commands:

REGSVR32 WUAPI.DLL

REGSVR32 WUAUENG.DLL

REGSVR32 WUAUENG1.DLL

REGSVR32 ATL.DLL

REGSVR32 WUCLTUI.DLL

REGSVR32 WUPS.DLL

REGSVR32 WUPS2.DLL

REGSVR32 WUWEB.DLL

After the above steps are finished. Sicne temporary folder of Windows Update

may be corrupted. We can refer to the following steps to rename this folder

that

1. Click Start, Run, type: cmd and press Enter. Please run the following

command in the opened window.

net stop WuAuServ

(note, you might need to reboot before the net stop command will work)

2. Click Start, Run, type: %windir% and press Enter.

3. In the opened folder, rename the folder SoftwareDistribution to SDold.

4. Click Start, Run, type: cmd and press Enter. Please run the following

command in the opened window.

net start WuAuServ

 

 

Teşekkürler

close
Güncel yazılarımı sana da paylaşmamı istersen, aşağıdaki bilgileri doldurarak abone olabilirsin.

Can Güneş

Microsoft Bulut Teknolojileri üzerine kafa yoran ve bu alanda kendini geliştiren birisi. Çalışıp öğrendiğim bilgileri sizlerle paylaşmak için bu internet sayfasını kurdum.

Bir cevap yazın

E-posta hesabınız yayımlanmayacak. Gerekli alanlar * ile işaretlenmişlerdir